Manual Lighting Procedure; Shutting Off Your Grill - Pit Boss 10923 Owner's Manual

MANUAL LIGHTING PROCEDURE

1. Open lid during lighting.
2. Set all control knobs to the "O" position.
3. Open the cylinder/gas valve according to the operating
instructions on tank.
4. Push and turn the burner control knob counter-clockwise to
" " (light position). Quickly and carefully, using a long match
or long-nosed lighter, place a lit flame near the burner and
watch the burner catch flame. Gain access to the burner from
beneath the cooking grates and heat tents. Position lit match
near the side of the burner.
CAUTION: Do not attempt to light another area of the
burner. This can cause injury.
5. If the burner does not light within 5 seconds, turn burner
Control Knob to "O", wait 5 minutes, and repeat lighting
instruction. After lighting, observe the burner flame. Make
sure all burner ports are lit and flame height matches
illustration shown previously.
NOTE: Each burner lights independently - repeat same steps for other burner.
WARNING: Never lean over the cooking area while lighting your gas grill. Keep your face and body a safe
distance (at least 457 mm / 18 inches) from the cooking grate surface when lighting your grill by match.
6. If the above points do not work, see Troubleshooting.

SHUTTING OFF YOUR GRILL

1. When finished cooking, turn gas cylinder valve to the CLOSED position, and allow the regulator knob to pop out. This safety
feature locks the regulator knob to ensure that the gas is no longer flowing.
2. Turn Control Knobs to the "O" position.
NOTE: A "poof" sound is normal as the last of the LP gas is burned.
3. Disconnect gas supply by following the Disconnecting A Gas Cylinder instructions.
WARNING: Allow the grill to cool completely, and remove the gas cylinder, before moving, travel, or for
storage.
13