How To Use - Java wellness L401 Assembly Instructions

Portable Vacuum Callus Remover
Please read and retain these instructions for future reference

How to Use

Start by removing the Emery pad cover by lifting it up on one side
(Fig. E).
Plug into the micro-USB connector end of the supplied USB cable
into the charging port of the Callus Remover (Fig. A). Plug the other
end of the USB cable into a USB wall adapter, then plug the adapter
into a wall socket.
Turn on the Vacuum Callus Remover by holding down the power
button for 2 seconds (Fig. B).
After turning on the unit is in low speed. To increase the speed to
high, click the power button once more.
To turn off the Vacuum Callus Remover hold down the power button until the light turns off.
Warning Do not immerse the unit in water or allow water anywhere near the unit. The Portable
Vacuum Callus Remover is not waterproof. Store in a dry place.
Holding the Callus Remover securely, gently press the emery pad to the thickest area of dead skin you want
to remove and slowly move outwards towards healthy skin (Fig. G).
Check intermittently for desired results. Once new, healthy skin is revealed or callus is removed, stop use
and switch the unit off.
The Enterprise
Department
L401
Fig A
UK Head Office, 11 Bridge Street, Bishop's Stortford, CM23 2JU
Tel: 0844 4824400*, Fax: 01279 756595
www.coopersofstortford.co.uk
EU address: D.S.B. LD, 160 Bd. de Fourmies, 59100 Roubaix, France
Tel: (+44) 1279 701269
*UK Calls cost around 7 pence per minute plus your telephone company's network access.
Please check with your telephone supplier.
Instructions for Use
v001: 24/10/22
Fig E
Fig G
Fig B