Kenwood NX-1700N-C User Manual page 73

DTMF (DUAL TONE MULTI FREQUENCY) CALLS
Note:
◆ DTMF calls can be made only in Analog Conventional Operations.
◆ Manual Dialing and Keypad Auto PTT are available only on Mobile transceivers
with microphone with keypad.
MAKING A DTMF CALL
Manual Dialing
1 Press and hold the PTT switch.
2
Enter the desired digits using the DTMF or microphone keypad.
• The corresponding DTMF tones sound each time you press a button.
If you release the PTT switch, transmit mode will end even if the complete
•
number has not been sent.
Keypad Auto PTT
If your dealer has activated the Keypad Auto PTT function, simply press the
buttons on the keypad or microphone to make the call.
• The DTMF code will be sent automatically when you press a button.
Store & Send
1
Enter the desired digits using the DTMF or microphone keypad.
• The digits appear on the display as you enter them.
You can enter digits by using the [ 0 ] ~ [ 9 ] , [ * ] or [ # ] buttons. Press
•
these buttons to cycle through the DTMF digits.
• You can enter up to 34 digits before transmitting.
2 After entering the complete number, press the PTT switch to transmit.
Note:
◆ If you switch the power OFF before transmitting the number, the number will be
cleared.
Stun Code
This function is used when a transceiver is stolen or lost.
When the transceiver receives a call containing a stun code, either the transmit
mode or both the receive and transmit mode will be disabled. The stun code is
canceled when the transceiver receives a call with a revive code.
73