Reheat Bread Rolls; Crumb Tray; Cleaning And Care; Storage - Silvercrest SDLT 1500 B1 Operation And Safety Notes

Reheat bread rolls

Do not put bread rolls straight into the device.
Instead, always use the bread roll rack
To set up the bread roll rack at full height
push the bread roll rack lever
until it locks into place.
Put the bread rolls on the bread roll rack
and ensure that they do not fall through the
bread roll rack
1
Set the toast setting knob
higher than 2. The toasting intensity depends
on the type of bread rolls.
Press the bread carriage lever
it locks into place. The blue indicator on the
stop button lights up.
4
Turn the bread rolls over as soon as the de-
sired reheating time is over and the bread
carriage lever
3
Push the bread carriage lever
locks into place. The blue indicator on the stop
button lights up.
4
Push the bread roll rack level
return the bread roll rack
position.

Crumb tray

CAUTION! RISK OF BURNS
DUE TO HOT SURFACES! The
crumb tray
surface of the device may get hot when the
device is operating.
When toasting, bread crumbs may fall
down. These are then caught in the crumb
tray .
9
Remove the crumb tray
to empty it.
Tip the crumbs out before sliding the crumb
tray back into the device.
9
10 GB/IE/NI
1
right down
8
.
to a setting no
7
down until
3
released.
down until it
3
upward to
8
to its original
1
and the outer
9
from the device
9

Cleaning and care

. plug from the socket before cleaning.
,
1
mains plug in water or other liquids.
Allow the product to cool down completely.
Do not use abrasive, aggressive or chemical
1
cleaning agents to clean the surface of the
device.
Use a damp, lint-free cloth to clean the de-
vice. Use a little mild detergent on the cloth
if necessary.
Clean the crumb tray
tergent. Rinse it carefully in clean water and
then dry it up.

Storage

Empty the crumb tray as described in
Cleaning and care.
Clean the device as described in
Cleaning and care.
Fully wrap the mains cable in the cable
winder
10
Store the device in a clean and dry place if
it is not used for a longer period of time.
Always remove the mains
Never put the product or the
with a neutral de-
9
under the device.