JVC HR-S8600EK Instructions Manual page 9

PRESET DO W N LO AD
SET THE TUNER CHANNELS BY D O W N LO AD IN G FRO M YO U R TV, CLOCK AN D GUIDE PROGRAM
NUMBERS
When you connect the recorder and your TV via fully-wired 21-pin SCART cable (
by downloading preset data from your TV instead of using the Auto Set Up function (
recorder sets the clock and VIDEO Plus+ assigned Guide Program numbers automatically.
For details, refer to the instruction manual for your TV.
ATTEN TIO N
You can use this function only with a TV offering T-V Link, etc.*
* Compatible with TVs offering T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully-wired 21-pin
SCART cable. The degree of compatibility and available functions may differ by system.
1
2
1 2
4 5
7 8
0
1
2
N O TES:
● In areas where no TV station transmits the PDC signal, the recorder cannot perform either auto clock set or auto Guide Program
number set.
● If there is a power cut, or if you press
turn off the recorder power once and try again from the beginning.
● Auto clock may not function properly depending on reception conditions.
● When you perform T-V LINK function, be sure to use fully-wired 21-pin SCART cable.
● On this recorder, the characters available for station names (ID) are A–Z, 0–9, –,
downloaded stations may differ from those on your TV (
Downloaded from: https://www.usersmanualguide.com/
1
8
– –:– –
3
6
9
3
4
4
3
2
3
or M EN U while downloading or set up is in progress, it will be interrupted; be sure to
Before performing the following procedure, make sure that:
the TV aerial cable is connected to the recorder and a 21-pin
SCART cable is connected between your TV and the recorder.
the mains power cord is plugged into the mains outlet.
batteries have been installed in the remote control.
Press . If "Auto" appears on the display
panel, Press % fi to select "CH – –" and
press O K or # . Preset position on the
display panel increases from "CH1";
do NOT press any button on the recorder
or remote control until the display panel
shows either the display as illustrated on
page 10 or "– – :– –".
● If "– –:– –" appears on the display panel, refer
to page 10.
● If you are using the on-screen display, the T-V
LINK screen will appear. Then the GUIDE
PROG SET screen will appear during Guide
Program number set.
● If you press any button on the recorder or
remote control while downloading is in
progress, this process will be interrupted and
you will need to start again. See NOTES below.
Press to turn off the recorder. Press
and hold down STO P on the recorder
until the display panel shows the display
as illustrated on the right. Press TV PRO G –
until the display panel shows "_OUT– –"
to set the Video Channel to off.
Press O K to exit Video Channel Set mode.
To view picture signals from the video recorder, set your TV to its AV mode.
— Refer to the instructions supplied with your TV set for how to do this.
pg. 58).
pg. 6), you can set the recorder's tuner channels
pg. 8). After downloading is completed, the
[MENU] : EXIT
GUIDE PROG SET
[MENU] : EXIT
* , + and (space). The names of some
9
T-V LINK
PLEASE WAIT
PLEASE WAIT