Connecting The Water Draining Hose To The Drain - Beko WFL100MA2 Manual

6.5 Connecting the water draining hose to the drain

• Attach the end of the drain hose directly to waste water
drain, washbasin or bathtub.
• Do not contact the discharged water. Risk of being burnt as
the water may be hot.
CAUTION!
• Fix the water drain hose end completely to prevent risk of
dislocation.
EN / 22
Fig f
a) Connect the water drain hose to a minimum height of 40 cm and a
maximum height of 100 cm.
b) The product may fail if water drain hose is at or close to floor level
(under 40 cm) as it would take water in and out continuously.
c) The product may fail if water drain hose is placed higher than 100 cm
as it cannot discharge water and water stays inside the product.
Therefore, follow the heights described in the figure.
f) Tighten the nut by hand to connect the
hose to washing machine as show in Fig f.
Never use a tool when tightening the nut.
g) Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any
leaks occur, turn off the tap and remove
the nut. Retighten the nut carefully after
checking the seal. Turn the tap on and
repeat the checks.
h) Keep the taps closed when the product is
not in use.
Washing Machine / User's Manual