Connecting Water Supply - Beko WFL100MA2 Manual

6.4 Connecting water supply

• The water supply pressure required to run the product is
between 1 to 10 bars (0.1 – 1 MPa). (It is necessary to have
10 – 80 litres of water flowing from the fully open tap per
minute.)
CAUTION!
- Attach a pressure reducing valve if water pressure is higher.
• Do not use old or used water inlet hoses on the new product.
- It may cause stains on your laundry and water leakage
• Do not plug the product's cold water inlet to hot water outlet.
- Your laundry may get damaged or the product will switch
take out
inlet hose
connector
Cap
water inlet
Fig a
hose
Fig d
Washing Machine / User's Manual
damages.
to protection mode and will not operate.
Screw
Bushing
Fig c
Screwdriver
Nuts
Fig b Fig e
a) Press down the cap, remove the inlet
hose connector as shown in Fig a.
b) Loosen four screws on the inlet hose
connector, put the connector on the tap
as shown in Fig b. If the tap caliber is too
large and the connector can not put on
it, loosen four screws and remove the
bushing as shown in Fig c.
c) Tighten four screws as shown in Fig d.
d) Tighten nuts as shown in Fig e
e) Connect other the end of the mains inlet
hose provided with the product to the
water inlet on the back of the product as
shown in the figure.
EN / 21