Zanussi ZOFR5005 Manual

Zanussi ZOFR5005 Manual

11 fin oil filled radiator with touch control


11 Fin Oil Filled Radiator with Touch Control
Model Number:
ZOFR5005 (B)
Product only suitable for well insulated spaces or occasional use
For Customer Services & Spare Parts please call 0330 1230 597
Or visit us at


Table of Contents

Summary of Contents for Zanussi ZOFR5005

  • Page 1 11 Fin Oil Filled Radiator with Touch Control Model Number: ZOFR5005 (B) Product only suitable for well insulated spaces or occasional use For Customer Services & Spare Parts please call 0330 1230 597 Or visit us at PLEASE RETAIN...
  • Page 2: Table Of Contents

    CONTENTS Page(s) Safety Instructions 3 - 5 Product Overview Base Assembly Using your Heater 8-11 Safety Instructions Cleaning and Care Problem Solving Guarantee and Customer Services Connection to the Mains Supply Specification Notes 18-19 Disposable Information...
  • Page 3: Safety Instructions

    SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should always be observed, including the following: • Read all instructions. • Check that the your mains voltage corresponds with the rating on the appliance. • The appliance must not be left unattended while it is connected to the mains supply.
  • Page 4 SAFETY INSTRUCTIONS • Never use the appliance in a room with explosive gas such as petrol, or while using any kinds of flammable glues, sprays or solvents. • The appliance must not be used with an extension lead. • Do not place any part of your body near the air inlet, outlet or on the fins ,to avoid personal injury, electric shock or fire.
  • Page 5 SAFETY INSTRUCTIONS • Warning: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to make sure that they do not play with the appliance.
  • Page 6: Product Overview

    PRODUCT OVERVIEW 1. Carry handle 2. Control panel 3. Cord wrap 4. Fins 5. Power cord 6. Castors...
  • Page 7: Base Assembly

    BASE ASSEMBLY 1. Turn the heater upside down. 2. As shown in Fig. 1, align the mounting holes on the caster assembly units with the screws on the caster pad plates, one at the bottom of the control panel and one at the bottom of the end radiator fin. 3.
  • Page 8: Using Your Heater

    USING YOUR HEATER Temperature Mode Selection Display Timer On/Standby Temperature Temperature Up Down First Time Setup 1. Plug in the appliance, you will hear an audible ‘beep’ for around 2 seconds. 2. Press the On/Standby [ ] button to power the appliance on.
  • Page 9 USING YOUR HEATER Operating Instructions Quick Use Press the On/Standby Button to turn on the heater. The default setting is high power at 35°C. Press and hold the Temperature Up [ + ] or the Temperature Down [ - ] to quickly set the heater to a desired temperature.
  • Page 10 USING YOUR HEATER Operating Instructions Your heater can also be scheduled to switch off after a certain amount of time. When the Heater is in operation, press the Timer button [ ] and then set the time by pressing the ‘+’ or ‘-’ buttons.
  • Page 11 USING YOUR HEATER Operating Instructions Remote Control The settings of the remote control are the same as on the Control Panel. On/Standby *Please be aware the button in the top left circled red is non- operational.
  • Page 12: Safety Instructions

    SAFETY FEATURES Safety Protection Devices – This appliance is fitted with an overheat and tip over protection system. 1. Overheat Protection – the power to the heating elements will automatically cut off if the temperature of the heating element exceeds a certain limit. In the event of overheating, the heater will stop operating.
  • Page 13: Cleaning And Care

    CLEANING AND CARE WARNING: Electrical Shock Hazard. Before you clean the appliance, disconnect the mains plug from the wall socket. • Allow the appliance to cool down completely before cleaning. • Do not immerse cord, plug or appliance in any liquid or allow moisture to come into contact with electrical parts.
  • Page 14: Problem Solving

    PROBLEM SOLVING My appliance does not work when I turn it on: 1. Check that your appliance is plugged in and the power is turned on at the mains socket. 2. Try another mains socket. 3. Check the appliance is in an upright position. 4.
  • Page 15: Guarantee And Customer Services

    GUARANTEE AND CUSTOMER SERVICES At Zanussi, we take all our customer feedback seriously. Feel free to contact our Customer Service Team on 0330 1230 597 who will be more than happy to assist you. This product is guaranteed for 12months from the date of the original purchase.
  • Page 16: Connection To The Mains Supply

    CONNECTION TO THE MAINS SUPPLY This appliance is designed to operate from a mains supply of 220-240V~50Hz. Check that the voltage marked on the product corresponds with your supply voltage. How to change the fuse 1. Slot the end of a screwdriver into the recess in the fuse holder of the plug.
  • Page 17: Specification

    SPECIFICATION Information requirements for electric local space heaters Model number ZOFR5005 (B) Item Symbol Value Unit Item Unit Heat Output Type of heat input, for electric storage local space heaters only Nominal heat Manual heat charge control, with output integrated thermostat...
  • Page 18: Notes

  • Page 19 NOTES...
  • Page 20: Disposable Information

    ZANUSSI is a registered trademark used under license from AB Electrolux (publ). Made under license by G2S Limited, Wigan, WN2 4AY/G2S (NI) Ltd, Belfast, BT5 5AD. For Customer Services & Spare Parts please call: 0330 1230 597 Or visit us at The ‘wheelie bin’...

This manual is also suitable for:


Table of Contents