Base Assembly - Zanussi ZOFR5005 Manual

1. Turn the heater upside down.
2. As shown in Fig. 1, align the mounting holes on the
caster assembly units with the screws on the caster
pad plates, one at the bottom of the control panel
and one at the bottom of the end radiator fin.
3. As shown in Fig. 2, proceed to place the 4 butterfly
nuts onto the each of the 4 screws and tighten as
much as possible.
4. Turn the heater around and check that it is stable on
the ground, if not repeat the above process again.
Fig. 1

BASE ASSEMBLY

Fig. 2
6
7