Zanussi ZESB7001 Manual

Zanussi ZESB7001 Manual

Electric blankets


Model Number:
ZESB7001 / ZEDB7002 / ZEKB7003
For Customer Services & Spare Parts please call 0330 1230 597
Or visit us at


Table of Contents

Subscribe to Our Youtube Channel

Summary of Contents for Zanussi ZESB7001

  • Page 1 ELECTRIC BLANKETS Model Number: ZESB7001 / ZEDB7002 / ZEKB7003 For Customer Services & Spare Parts please call 0330 1230 597 Or visit us at PLEASE RETAIN FOR FUTURE REFERENCE...
  • Page 2: Table Of Contents

    CONTENTS Page(s) Safety Instructions 3 - 5 Securing Your Blanket to the Bed Feature Diagram Using your Blanket 8-10 Cleaning and Care 11-13 Problem Solving Guarantee and Customer Services Connection to the Mains Supply Specification Notes 18-19 Disposable Information...
  • Page 3: Safety Instructions

    SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should always be observed, including the following: • Read all instructions. • Check that your mains voltage corresponds with the rating on the appliance. • To protect against electrical shock do not immerse cord, plug, or appliance in water or other liquid.
  • Page 4 SAFETY INSTRUCTIONS • Make sure that the heating area (wire element) on any side of the bed does not hang over the edge of the mattress and that the following instructions are read carefully before using the blanket. • Do not use this blanket for infants, persons with no/limited mobility or heat sensitivity conditions.
  • Page 5 SAFETY INSTRUCTIONS • Do not switch the power on if the blanket is wet or in a folded state. • Do not dry-clean this blanket. Cleaning liquids may have a deleterious effect on the insulation or covering of the heating unit. It is recommended you follow instructions for localized soiling or hand washing if soiling occurs.
  • Page 6: Securing Your Blanket To The Bed

    SECURING YOUR ELECTRIC BLANKET Note: • Use only as an under blanket and do not use above the occupant of the bed. • This product can be used with any type of bedding including waterproof bed protectors. • Tuck this blanket securely to the mattress. •...
  • Page 7: Feature Diagram

    FEATURE DIAGRAM 1. Electric blanket 4. Skirt (this is located on 2. Detachable power cord the side of the blanket) 3. Controller...
  • Page 8: Using Your Blanket

    USING YOUR ELECTRIC BLANKET Controls Note: On initial use it is recommended that the blanket be set on setting ‘9’ for 30 minutes before sleeping on the bed and then set to setting ‘1’ for continuous use. Preset on ‘9’ will assist in drying out any moisture which has been accumulated in the mattress.
  • Page 9 USING YOUR ELECTRIC BLANKET 1. Ensure the blanket is fitted to the bed correctly, see the Securing your electric blanket section. 2. Plug the power lead into the closest socket, using an extension lead, if needed, to ensure that the lead is not stretched. 3.
  • Page 10 USING YOUR ELECTRIC BLANKET Safety Protective Devices The appliance is fitted with an over heat protection system The system will remain dormant indefinitely as long as the blanket is operating in the normal temperature range. If, for any reason, the blanket is operated in an abnormal situation or condition which would otherwise have induced a rapid temperature rise high enough to constitute a hazard, the over heat protection should intervene by cutting off the supply...
  • Page 11: Cleaning And Care

    CLEANING AND CARE WARNING: Electrical Shock Hazard. Note: Before cleaning, ensure the control is set to the ‘0’ Position (OFF) and remove the plug from the wall socket. Note: Do not allow the controller to come in contact with any wet solution.
  • Page 12 CLEANING AND CARE Washing instructions Only use the below instructions: • Hand wash or spot clean • Do not machine wash above 40°c • Do not tumble dry • Do not wring • Do not bleach • Do not dry clean •...
  • Page 13 CLEANING AND CARE • Rinse the blanket thoroughly in clean fresh water. • Unfolded the blanket and allow to dry naturally. Hand Washing • Immerse the blanket only (do not allow the controller to come in contact with any wet solution) in a luke warm neutral detergent or mild soapy solution.
  • Page 14: Problem Solving

    PROBLEM SOLVING My appliance does not work when I turn it on: 1. Check that your appliance is plugged in and the power is turned on at the mains socket. 2. Try another mains socket. 3. Check that the control has been set to the correct setting and is not in the off position 4.
  • Page 15: Guarantee And Customer Services

    GUARANTEE AND CUSTOMER SERVICES At Zanussi, we take all our customer feedback seriously. Feel free to contact our Customer Service Team, on 0330 1230 597, who will be more than happy to assist you. This product is guaranteed for 12 months from the date of the original purchase.
  • Page 16: Connection To The Mains Supply

    CONNECTION TO THE MAINS SUPPLY This appliance is designed to operate from a mains supply of 220-240V~50Hz. Check that the voltage marked on the product corresponds with your supply voltage. How to change the fuse 1. Slot the end of a screwdriver into the recess in the fuse holder of the plug.
  • Page 17: Specification

    SPECIFICATION Model number ZESB7001 Rated voltage 220V - 240V ~ 50Hz Power consumption Product dimensions (CMS) (W)107 x (L)203 Model number ZEDB7002 Rated voltage 220V - 240V ~ 50Hz Power consumption 2 x 60W Product dimensions (CMS) (W)135 x (L)190...
  • Page 18: Notes

  • Page 19 NOTES...
  • Page 20: Disposable Information

    0330 1230 597 Or visit us at Revision 1.6 ZANUSSI is a registered trademark used under license from AB Electrolux (publ). Made under license by G2S Limited, Wigan, WN2 4AY. This symbol is known as the 'Crossed-out wheelie bin Symbol'. When...

This manual is also suitable for:


Table of Contents