Settings - Electrolux EWF1023BDWA User Manual

●
At the end of the Vapour cycle, the
clothes will be warmer, softer and
detached from the drum.
NOTE
If Vapour option is selected, rinse
temperatures will be elevated.
During a vapour cycle, you may notice
vapour exiting from the drain hose of
the washing machine, this is normal
and there is no cause for alarm.
Prewash ( ) Touchpad
Select this option if you wish your laundry
to be pre-washed before the main wash.
Use this option for heavy soil. The
indicator of this option will be on.
When you set this function, put the
detergent into the "
This function increases the program
duration.
Stain Touchpad
Press this touchpad to add the stain
phase to a program. The indicator of this
option comes on.
Use this function for laundry with hard
stains to remove.
When you set this function, put the stain
remover into " " compartment.
This function increases the program
duration.
Stain option can be combined with
temperature 40 to 90 °C only.

3.5 Settings

Save Favourite (
Program settings that are frequently used
can be saved (e.g. Cotton, 60°C, 1200
rpm, with Prewash and Vapour).
To program/re-program Favourite with
your own selections and save them,
proceed as follows:
1. Put machine in Stand-By mode.
2. Select your desired wash settings.
" compartment.
) Program
3. To save favourite program, press and
hold "Vapour
2 seconds and you will hear "Bip, Bip"
sound and "
display.
To recall the favourite wash program,
turn selector knob to "Favourite
program. You will get acknowledgement
on the display when the Favourite
program is loaded.
Child Safety Lock (
Your appliance is provided with CHILD
SAFETY LOCK which permits you to
leave the appliance unsupervised with
the door closed without having to worry
that children might be injured by or cause
damage to the appliance.
Set this option after pressing the
Start/Pause touchpad.
To set "Child Lock" option:
●
To activate the function, press and
hold "Prewash" touchpad about
2 seconds until the display shows the
icon " ".
If you press any touchpad while
Child Lock is activated, the icon
" " will flash on display 3 times
along with buzzer sound.
The touchpads are locked
(except for the On/Off button).
● To deactivate the function, press and
hold "Prewash" touchpad about
2 seconds until the icon "
This function remains enabled
even after the appliance is
switched off.
Enabling/Disabling End-Of-Wash
Buzzer
This setting permits you to either enable
or disable the buzzer at the end of the
program. As an example, you might wish
to disable this buzzer when you start a
wash when going to bed, so that when
the wash finished approximately 1 hour
later, it will not disturb you through the
night.
ENGLISH
" touchpad about
" is flashing on the
"
) Option
" goes off.
15