LG LDFC242 Series Owner's Manual page 16

16 INSTALLATION
4
Remove the junction box from the appliance.
5
Insert a 3/8" strain relief
in the junction box. Tighten the ring nut
secure it in place.
6
Insert the electrical cable through the hole in
the strain relief. Tighten 2 screws to secure
the cable.
7
Pull the existing wires through the openings
in the junction box. Tighten 2 screws
reassemble the junction box in the appliance.
through the hole
b
to
c
to
d
8
Pair the white, black, and green wires to the
matching colored wires from the dishwasher.
Then twist on the provided wire nuts
to connect the corresponding wires.
9
Wrap electrical tape
connection.
10
Fold the connected wires back into the
junction box and screw on the junction box
cover.
WARNING
• Verify that the black wire is hot (120 V). If not, or
if you are unsure of the power supply, have it
checked by a licensed electrician.
CAUTION
• Do not leave stripped wire exposed. Trim
stripped wire to fit completely inside wire nuts.
tightly
e
around each
f