Troubleshooting
Problem
The unit does not work.
The unit does not ring.
The display is blank.
You cannot dial.
The other party suddenly
cannot hear your voice
during a conversation.
You cannot program items
such as the dialing mode.
You cannot store a name
and phone number in
memory.
While programming or
searching, the unit starts to
ring and stops the program/
search.
For assistance, please call: 1-800-211-PANA(7262)
Cause and Remedy
• Check the settings (p. 6 – 14).
• Remove the batteries and reinstall them
to reset the unit.
• The ringer selector is set to OFF. Set to
HIGH or LOW (p. 11).
• Install new batteries (p. 34).
• Check that the dialing mode selection is
correct (p. 10).
• The dialed number is restricted. To
cancel, see page 32.
• [MUTE] may have been pressed during
the conversation. If "
press [MUTE].
• Programming is not possible when the
handset is off the cradle.
• Do not pause for over 60 seconds while
programming.
• When using the Call Restriction feature
(p. 32), you cannot store an emergency
number in the Phone Book List.
• If "PHONEBOOK FULL" is displayed,
erase other stored items from the Phone
Book List (p. 28).
• Programming is not possible when the
handset is off the cradle.
• Check that the batteries are installed in
the unit and that the battery power is not
low.
• Do not pause for over 60 seconds while
storing.
• Do not enter a phone number more than
22 digits long.
• To answer the call, lift the handset. Start
again from the beginning after hanging
up.
" is displayed,
35