Rear Panel - JVC AV-P950U/E Instructions Manual

Rear panel

• All switches are
factory-set to "1".
Mode setting for the RGB
output picture
XGA (1024 X 768) ........ 1 1
SVGA (800 X 600) ........ 0 1
VGA (640 X 480)
• When using either SVGA or VGA mode,
the picture quality will be slightly inferior
to that of XGA mode.
Use to control the unit from a personal
computer via RS-232C(see page 16).
Input RGB signals such as video signal from a personal
computer, or sync signal.
Use to input RGB signals such as video signals from a
personal computer, and sync signals. Select the picture
to be shown instead of the camera picture using the EXT
IN button of SOURCE SELECT on the control panel.
• Input signals will be transferred directly to RGB
OUTPUT 1 and RGB OUTPUT 2, regardless of the
picture mode settings of RGB OUTPUT on this unit.
• Set the signal of the equipment connected to the
EXT INPUT connector according to the
specifications of the connected projector or display.
8
Downloaded from: https://www.usersmanualguide.com/
A B C D E F
1
0
A B
........ 0 0
REMOTE IN
EXT INPUT
MODE
Use to set the RGB output picture mode or sync signal
mode. Set it according to the specifications of the
connected projector or display.
Preview mode setting
(see page 14)
Menu display setting
• If No Display is selected for the MENU Display setting
while the PREVIEW mode setting is ON, this setting will be
applicable only with the RGB output pictures.
Setting of sync signal for
G signal from RGB OUTPUT
Mode setting for sync
signal from RGB OUTPUT
REMOTE INPUT (RS-232C)
A B C D E F
1
0
MODE
EXT INPUT
RGB OUTPUT 1
RGB OUTPUT1, RGB OUTPUT2
RGB OUTPUT1, RGB OUTPUT2
Outputs camera pictures or signals from EXT
INPUT.
1 .... OFF
0 .... ON
1 .... Display
0 .... No display
1 .... NO (not added)
0 .... YES (added)
1 .... Horizontal sync signal
0 .... Composite sync signal
DC OUTPUT
DC12V 400mA
RGB OUTPUT 2