Hob - Daily Use; Burner Overview - Zanussi ZCG61026XA User Manual

Table of Contents

Advertisement

PREHEATING
Preheat the empty appliance to burn off the
remaining grease.
1. Set the oven function knob to maximum gas
flow position
.
Refer to "Oven - Daily use" chapter.
2. Let the appliance operate for approximately 1
hour.
WARNING! Accessories can become
hotter than usual.

HOB - DAILY USE

WARNING! Refer to Safety chapters.
IGNITION OF THE HOB BURNER
Always light the burner before you put
on the cookware.
WARNING! Be very careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in case of
the flame misuse.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut.
It is normal.
In the absence of electricity you can
ignite the burner manually.
Ignition of a hob burner with the
thermocouple
For manual ignition put the flame near the
burner. Push the knob for the hob down and
turn it counterclockwise to the maximum gas
flow position
.
For ignition with spark generator button push
and hold the spark generator button
same time push the knob for the hob down and
turn it counterclockwise to the maximum gas
flow position
. Release the spark generator
button when burner lights.
Keep the knob for the hob pushed for equal or less
than 10 seconds to let the thermocouple warm up.
If not, the gas supply is interrupted.
Adjust the flame after it is regular.
8
The appliance can emit an odour and smoke. This is
normal. Make sure that the airflow is sufficient.
Let the oven cool down. Dampen a soft cloth with
warm water and a little mild washing-up liquid and
use this to clean the oven cavity.
WARNING! Do not keep the knob
pushed for more than 15 seconds. If
the burner does not light after 15
seconds, release the knob, turn it into
the off position and try to light the
burner again after minimum 1 minute.
If after some tries the burner does not
light, check if the crown and its cap
are in the correct position.
If the burner accidentally goes out,
turn the knob to the off position and try
to light the burner again after minimum
1 minute.

BURNER OVERVIEW

. At the
A. Burner cap
B. Burner crown
C. Ignition candle
D. Thermocouple (if applicable)
A
B
C
D

Advertisement

Table of Contents
loading

Table of Contents