Table of Contents
Advertisement
82
EN
SYMPTOM
24. Even when Slow Shutter is
not selected, the image looks
like it is activated.
25. There is no strobe when the
Classic Film or Strobe mode
is activated.
26. White Balance cannot be
activated.
27. When shooting a subject
illuminated by bright light,
vertical lines appear.
28. When the screen is under
direct sunlight during
shooting, the screen becomes
red or black for an instant.
29. During recording, the date/
time does not appear.
30. Files stored in the
MultiMediaCard cannot be
deleted.
31. The indicators and messages
do not appear.
32. Images on the LCD monitor
appear dark or whitish.
33. The rear of the LCD monitor
is hot.
34. The indicators and the image
colour on the LCD monitor
are not clear.
Downloaded from:
24. • When shooting in the dark,
25. • The Picture Wipe or Dissolve
26. • The Sepia or Monotone mode
27. • This is a result of exceedingly
28. • This is not a malfunction.
29. • "DATE/TIME" is set to "OFF"
• Self-Recording is performed.
30. • Files stored in the
31. • "ON SCREEN" is set to
32. • In places subject to low
• When the LCD monitor's
33. • The light used to illuminate
34. • This may occur when the
https://www.usersmanualguide.com/
TROUBLESHOOTING
POSSIBLE CAUSES
the unit becomes highly
sensitive to light and the
image takes on an effect
similar to Slow Shutter.
function is in use.
is activated.
high contrast, and is not a
malfunction.
in the Menu Screen.
MultiMediaCard are protected.
"SIMPLE" or "TIME CODE" is
set to "OFF" in the Menu
Screen.
temperature, images become
dark due to the characteristics
of the LCD monitor. When
this happens, the displayed
colours differ from those that
are actually recorded. This is
not a defect of the camcorder.
fluorescent light reaches the
end of its service life, images
on the LCD monitor become
dark. Consult your nearest
JVC dealer.
the LCD monitor causes it to
become hot.
surface or the edge of the LCD
monitor is pressed.
CORRECTIVE ACTION
24. • If you want the lighting to
look more natural, set GAIN
UP to "AGC" or "OFF" in the
Menu Screen (
pg. 27).
25. • Do not try to use the Classic
Film or Strobe mode during a
scene transition (
36).
26. • Turn off Sepia or Monotone
before setting White Balance
(
pg. 36, 39).
27.
————
28.
————
29. • Set "DATE/TIME" to "ON" in
the Menu Screen (
• During Self-Recording, the
date/time does not appear
(
pg. 17).
30. • Remove protection from the
files stored in the
MultiMediaCard and delete
them (
pg. 48, 49).
31. • Set "ON SCREEN" to "LCD"
or "LCD/TV" and set "TIME
CODE" to "ON" in the Menu
Screen (
pg. 29, 41).
32. • Adjust the brightness and
angle of the LCD monitor
(
pg. 16, 17).
33. • Close the LCD monitor to turn
it off or set the POWER
Switch to "OFF", and let the
unit cool down.
34.
————
(cont.)
pg. 34,
pg. 29).
Advertisement
Table of Contents
