Table of Contents
Advertisement
Case
CAUTION
•
When designing the inlet and outlet, the above aperture area must be satisfied. Failure to do so may result in issues
with the product, which are not covered by the warranty.
•
When installing a separate case on the product, consider the recommended aperture area and aperture ratio when
designing. Failure to meet the recommended aperture plane and aperture ratio may cause the product to malfunction.
In such cases, the warranty does not apply.
NOTE
•
The partition should be in close contact with both the case and the product when installed.
•
It is recommended that the inlet and outlet be positioned at the same location as the product.
•
If possible, install an air vent around the inlet and outlet of the product.
•
When installing on both sides or installing multiple products together, the aperture area must be increased by the
number of products installed.
•
The images in the User Manual are for horizontal installation. However, vertical installation is also possible, in which
case it is necessary to secure the same aperture area.
Product
Product
23
100 mm
200 mm
Advertisement
Table of Contents
