AEG OSC6N181ES User Manual page 8

Overall space required in use ³
H3 (A+B) mm
W3 mm
D3 mm
³ the height, width and depth of the appliance
including the handle, plus the space
necessary for free circulation of the cooling
air, plus the space necessary to allow door
opening to the minimum angle permitting
removal of all internal equipment
3.2 Location
To ensure appliance's best functionality, you
should not install the appliance in a place with
direct sunlight. Do not install the appliance
close to radiators or cookers, ovens, or hobs,
unless otherwise specified in the installation
instructions.
Make sure that air can circulate freely around
the back of the cabinet.
This appliance should be installed in a dry,
well ventilated indoor position.
This appliance is intended to be used at
ambient temperature ranging from 10°C to
43°C.
The correct operation of the appliance
can only be guaranteed within the
specified temperature range.
If you have any doubts regarding where
to install the appliance, please turn to the
vendor, to our customer service or to the
nearest Authorised Service Centre.
It must be possible to disconnect the
appliance from the mains power supply.
The plug must therefore be easily
accessible after installation.
8 ENGLISH
3.3 Electrical Connection
1816
Any electrical work required to install this
546
appliance should be carried out by a
qualified electrician or competent person.
1068
This appliance must be earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
The wires in the mains lead are coloured in
accordance with the following code:
• A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. Connect the wire coloured green and
2. Connect the wire coloured blue to the
3. Connect the wire coloured brown to the
4. Check that no cut, or stray strands of wire
CAUTION!
WARNING!
A B
yellow to the terminal marked either with
the letter "E" or by the earth symbol
coloured green and yellow.
terminal either marked with the letter
"N" or coloured black.
terminal either marked with the "L" or
coloured red.
is present and the cord clamp (E) is
secure over the outer sheath.
C
D
E
or