AEG OSC6N181ES User Manual page 17

Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
Some specific surfaces inside the
fridge compartment are warmer at
some times.
Temperature setting LEDs flash at
the same time.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
Possible cause
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The Frostmatic function is switched
on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The door has been opened often.
The Frostmatic function is switched
on.
There is no cold air circulation in the
appliance.
An error has occurred in measuring
the temperature.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Solution
Attach the melting water outlet to
the evaporative tray.
Switch off Frostmatic function man‐
ually, or wait until the function deac‐
tivates automatically to set the tem‐
perature. Refer to "Frostmatic func‐
tion" section.
Refer to "Closing the door" section.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.
Open the door only if necessary.
Refer to "Frostmatic function" sec‐
tion.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
"Hints and tips" chapter.
This is a normal state.
Contact the nearest Authorised
Service Centre. The cooling system
will continue to keep food products
cold, but temperature adjustment
will not be possible.
installation instructions.
gaskets. Contact the Authorised Service
Centre.
ENGLISH 17