Table of Contents
Advertisement
To Connect to the CLI:
1. Connect the FortiManager unit's console port to the management
computer using the provided console cable.
2. Start a terminal emulation program on the management computer. Use
the following settings:
• Baud Rate:
9600
• Data bits:
8
• Parity:
None
• Stop bits:
1
• Flow Control: None
3. Press Enter on your keyboard to connect to the CLI.
4. Type admin in the Name field, leave the Password field blank, and
press Enter.
You can now proceed with configuring your FortiManager unit.
Reset the FortiManager unit to factory default settings:
To reset the FortiManager unit to the factory default settings from the CLI,
enter the following command:
execute reset all-settings
Shutting Down the FortiManager unit:
Caution: Not following this procedure can increase the risk of damaging
or corrupting the unit's hard disk drive.
When powering off the FortiManager unit, always shut down the unit
using the following procedures before disconnecting the power supply.
To shut down the FortiManager unit using the CLI, enter the following
command:
execute shutdown
You can also shut down the FortiManager unit in the Web-based
Manager. Go to System Settings > General > Dashboard, select
Shutdown in the Unit Operation dashboard widget and select OK.
4. Technical Specifications
Power
Video
LCD
button
interface
menu
LCD
USB interfaces
buttons
panel
(Not supported)
FortiManager 1000C
2TB Hard disk drive
Hard disk drive bay
Console interface
Ports 1-2
Video interface
USB interfaces
(Not supported)
(Not supported)
Interface
Protocol
Description
Hard disk drive
SATA
One 2TB 3.5" SATA Hard disk drive is
provided. The FortiManager 1000C
supports up to four hard disk drives.
USB interfaces 1-2
USB 2.0
Not supported.
(Front)
USB interfaces 3-4
USB 2.0
Not supported.
(Rear)
Console Port
RS-232
Optional serial connection to the
Management Computer. Also gives
access to the CLI.
Video interface
A single port that connects to a monitor
(Front)
system.
Video interface
Not supported.
(Rear)
Ethernet Ports
Gigabit
Gigabit Ethernet ports for connection to
Gb1, Gb2, Port3,
Ethernet
your network and the Internet
Port 4
Front
System ID
DVD-ROM
panel
drive
Hard disk drive bay
Hard disk drive bay
Ports 3-4
BYPASS
3
4
FortiModule-CP7-RJ45
HA
System status
Power supply
LED
System ID
button
Back
Default IP
Address
Gb1 (port 1)
interface IP:
192.168.1.99
Advertisement
Table of Contents
