Cleaning Instructions - e-Bikelifter BM-60-S Instruction Manual

12 Cleaning instructions

Model-approved IP code:
Solid particle protection
Liquid ingress protection
(with batteries)
Always wear the correct safety equipment while cleaning
l
Lower the lifting tool, so that you don't risk a head injury when cleaning near the floor.
l
The battery charger must be disconnected from the main during cleaning.
l
Use a standard pH neutral
l
cleaning detergent.
The outer surfaces can be
l
cleaned using a wet brush
or a damp cloth.
Check the proper function of all components before the e-bike lifter is put back into oper-
l
ation after cleaning.
16
Ingress protection marking (IP)
IP 41
IP 4X >1 mm
IP X1 Dripping water Dripping water (vertically falling drops)
Special instructions/Precautions
Detergent application
Work process
Key inspection points
www.e-bikelifter.com
IP code description
Most wires, slender screws, large ants etc.
shall have no harmful effect on the spe-
cimen when mounted in an upright position
onto a turntable and rotated at 1 RPM.
Do not use acid, alkaline or harsh chem-
l
ical products, these might weaken the
drive belt and other sensitive com-
ponents or leave marks on the surfaces.
Do not use liquids to clean the e-
l
Bikelifter as this may have adverse
effect on the electrical components.