Table of Contents
Advertisement
9 Rechargeable batteries and chargers
Batteries
The Valve Regulated Lead Acid (VRLA) batteries are non-spillable and
sealed with pressure release vents. The batteries are housed in the control
box and should not require maintenance other than the regular charging.
Under normal operation conditions, materials sealed inside is not haz-
ardous to people's health.
The batteries are charged with the external charger.
Connect the charger to the charging port on the backside of the
e-Bikelifter and to a 230V / 110V – 50-60 Hz power source.
Although the device charges both when switched on and when switched
off, the e-bike lifter should not be used while charging!
The batteries should be charged regularly, as a total discharge can
damage the batteries or reduce their lifetime. If a deep discharge does
occur, charge the batteries for min. 4 hours before using the e-bike lifter
again. Workshops are recommended to charge the e-Bikelifter on week-
ends.
A full battery charge, allows approx. 80 cycles with complete lifting and
lowering of the maximum load of 30 kg!
Charger
The charger automatically charges the batteries and switches off when the batteries are fully charged.
Charging the batteries takes approx. 5 hours.
Charger indicator:
n
Red indicator:
The charger is connected to main power and charging.
n
Green indicator:
Float charging and ready for use.
Safety when charging
Use only original charger. Check that the wires are in good condition, connected properly
before applying power. Make sure there are no dirt or water in the plug.
14
www.e-bikelifter.com
Advertisement
Table of Contents
