Table of Contents
Advertisement
Problem
When a second call is
received during a
conversation, the unit does
not display the new caller's
name and/or phone number.
(HANDSET!LOCATOR)
not function.
You cannot redial by
pressing
(REDIAL/PAUSE)
"Recharge battery" is
displayed on the handset,
"
" flashes or the unit
beeps intermittently.
You charged the battery
fully, but "Recharge
battery" is still displayed
and/or "
" continues to
flash.
The IN USE/CHARGE
indicator light does not go
out while charging.
•The line mode selection is incorrect. See
page 15.
•The handset is too far from the base
does
unit.
•The handset is engaged in an outside
call or is viewing the Caller List/directory
list. Wait until the IN USE/CHARGE
indicator light goes out.
•If the last number dialed was more than
.
32 digits long, the number will not be
redialed correctly.
•Access numbers entered after pressing
(TONE)
redialing.
•The button has a double function as
either redial or pause. It will redial the
last number dialed if pressed at the
outset of a call (p. 19). If another
number has been dialed first, it will
operate as a pause button (p. 44).
•Charge the battery fully (p. 12).
•Clean the charge contacts and charge
again (p. 13).
•Install a new battery (p. 49).
•This is normal.
Remedy
will not be included when
53
Advertisement
Table of Contents
