Macab DT-2200 Manual page 10

MANUAL
DT-2200
Programming
SEARCHING FOR CHANNELS
After adjusting the settings for the required transponders, a channel
search will be carried out. A QPSK lid (yellow LED, constant light)
must be present in order to find any channels. If the alarm lights up (red
LED) the installation and settings must be checked.
Select YES and press the Enter button to start the channel search.
ENTER
The display indicates that the search is in progress. After completion
a menu will appear displaying all channels which were found on
the transponder. Select NO to set the PID, see page 61.
Use the Up/Down buttons to select a required channel.
Press the Enter button and after a few seconds the channel will
ENTER
be displayed on the TV screen.
: PIDs are only to be used when you have problems finding
Important
a required channel.
CHANGING CHANNEL
Switching to another channel within the transponder is simply done by
using the buttons and the display on the front panel of the DT-2200.
Press the Left button.
Use the Up/Down buttons to select a channel.
Press the Enter button and after a few seconds the channel
ENTER
will be displayed on the TV screen.
58
01042-4 DT-2200 ENG-1.p65 58
START TRANS
SCAN YES
SCANNING....
PLEASE WAIT
DISCOVERY
(VIDEO)
DISCOVERY
2001-09-26, 08:46