Elecom UCAM-E1C10 Series Setup Manual page 3

4. Select "完全" and then click on the
button.
5.
Click on the
Installation will begin.
6.
Click on the
7.
Peel off the sticker from the USB connec-
tor of the PC camera.
button.
button.
8.
Plug the USB connector of the PC cam-
era into a USB port of the PC.
The PC camera may be connected
and disconnected while power to the
PC is ON.
Do not try plugging the USB connector
in upside-down.
This completes Driver Utility installation.
Next, check that the Driver Utility was correctly
installed. Go to pg. 10.
Though this PC camera consumes a
maximum 100 mA of power, because of
specifications, connect it to a USB port
that supplies 500 mA.
3