Table of Contents
Advertisement
2. Reinstall the air duct to the magnetron with the two (2)
screws.
3. Reinstall the magnetron to the waveguide flange with
the three (3) screws.
4. Reinstall the thermistor angle to the magnetron with the
one (1) screw.
5. Reinstall the temperature fuse (magnetron) to the air
duct with the one (1) screw.
6. Reinstall the snap band of the main wire harness to the
air duct.
1. Disconnect the power supply cord and then remove the
outer case.
2. Open the oven door and block it open.
3. Discharge the high voltage capacitor.
4. Remove the magnetron with the air duct and the reflector
POSITIVE LOCK
1. Disconnect the power supply cord, and then remove
outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Push the lever of positive lock
5. Pull down on the positive lock
CAUTION: WHEN CONNECTING THE POSITIVE LOCK
CONNECTORS TO THE TERMINALS, CON-
NECT THE POSITIVE LOCK
LEVER FACES YOU
1. Disconnect the power supply cord and then remove
outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Disconnect the wire leads and connectors from control unit.
1. Disconnect the power supply cord and then remove the
outer case.
2. Open the oven door and block it open.
3. Discharge the high voltage capacitor.
4. Remove the control panel assembly, referring to chapter
of "CONTROL PANEL ASSEMBLY REMOVAL".
5. Disconnect the connector CN-D of the switch unit from
the control unit.
6. Remove the four (4) screws holding the control unit to
the control panel frame, and remove the control unit.
1. Disconnect the power supply cord and then remove the
outer case.
OVEN LAMP REMOVAL
®
CONNECTOR (NO-CASE TYPE) REMOVAL
®
connector.
®
connector.
®
®
SO THAT THE
CONTROL PANEL ASSEMBLY REMOVAL
CONTROL UNIT ASSEMBLY REMOVAL
UPPER HEATER REMOVAL
7. Reinstall the chassis support to the oven cavity front
flange and the bottom plate assembly with the two (2)
screws.
8. Reconnect the wire leads to the magnetron, oven lamp,
referring to "PICTORIAL DIAGRAM".
9. Reinstall the outer case and check the oven is operating
properly.
CAUTION: WHEN REPLACING MAGNETRON, BE SURE
THE R.F. GASKET IS IN PLACE AND MOUNT-
ING SCREWS ARE TIGHTENED SECURELY.
from the waveguide flange, referring to the items 4 -10
of "Removal of MAGNETRON REPLACEMENT"
5. Remove the one (1) screw holding the oven lamp to the
air duct.
6. Now, the oven lamp is free.
Figure C-1. Positive lock
5. Remove the one (1) screw holding the control panel
assembly to the oven cavity front flange.
6. Slide the control panel assembly upward and remove it.
7. Now, individual components can be removed.
7. Remove the eight (8) screws holding the switch unit to
the control panel frame, and remove the switch unit.
8. Pulling the timer knob and the switch unit at the same
time, carefully remove the switch unit from the control
panel frame so that the switch unit is not broken.
9. Now, the control unit assembly is free.
NOTE: When the switch unit is reinstalled, with fitting
the "D" cut position of the rotaly encoder shaft
and timer knob.
2. Open the oven door and block it open.
3. Discharge the high voltage capacitor.
29
Terminal
Positive lock®
connector
1
Push
Lever
2
Pull down
®
connector
R-55TS-F
Advertisement
Table of Contents
