Bosch WNA13401ES User Manual page 47

Fault
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
Detergent residue on
the dry laundry.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
Fluff on the laundry.
Water inlet noise dur-
ing the drying phase.
Drying programme
does not start.
Cause and troubleshooting
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶
Water inlet hose is not correctly/securely connected.
Connect the water supply hose correctly.
1.
→ "Connecting the water inlet hose", Page 15
Tighten the screw connection.
2.
The water outlet hose is damaged.
Replace the damaged water outlet hose.
▶
Water outlet hose is not connected correctly.
Connect the water outlet hose correctly.
▶
→ "Water outlet connection types", Page 16
Fluff has accumulated in the drum.
Run the Algodón/Algodão 90° programme without
▶
any laundry or detergent.
Drying phase requires water.
Not a fault.
1.
Make sure that the water tap also remains open
2.
during the drying phase.
Door is not closed.
Close the door.
1.
Press ⁠ Inicio/Pausa + Carga to start the pro-
2.
gramme.
No drying programme is selected.
Troubleshooting en
47