LG LTGL6937 Series Owner's Manual page 70

70 TROUBLESHOOTING
Problem
Clock and timer does
not work.
Oven light does not
work.
Oven will not Self
Clean. (On some
models)
Oven door does not
open after a Self
Clean cycle (On some
models)
The oven is not clean
after a Self Clean
cycle (On some
models)
CLEAN and door
flash in the display
(On some models)
"Loc" is on in the
display when you
want to cook (On
some models)
Oven control beeps
and displays any F
code error.
Oven control
displays Sb/5b/S6/56
error code.
The oven racks were
cleaned in a Self
Clean cycle. (On
some models)
Displayed colon in
the clock is flashing
Improper oven control settings
• See "Changing Oven Settings" in the OPERATION chapter.
It is time to replace the lamp or the lamp is loose.
• Replace or tighten lamp. See "Changing the Oven Light" section in this Owner's Manual.
The plug on the range is not completely inserted in the electrical outlet.
• Make sure the electrical plug is inserted into a live, properly grounded outlet.
The oven temperature is too high to set a Self Clean operation.
• Allow the range to cool and reset the controls.
Oven controls improperly set.
• See the Self Clean section.
A Self Clean cycle cannot be started if the oven Control Lock / Lockout feature is active.
• See the "Control Lock / Lockout" in "Changing Oven Settings" section.
Oven is too hot.
• Allow the oven to cool below locking temperature.
The control and door may be locked.
• Allow about one hour for the oven to cool after the completion of a Self Clean cycle. The
door can be opened when the lock
Oven controls not properly set.
• See the Self Clean section.
Oven was heavily soiled.
• Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to
Self Clean again or for a longer period of time.
The Self Clean cycle has been selected, but the door is not closed.
• Close the oven door.
The oven is locked because of the Control Lock / Lockout feature.
• Deactivate the Control Lock / Lockout feature.
Electronic control has detected a fault condition.
• Remove the power from the range for five minutes and then reconnect the power. If the
function error code repeats, call for service.
• Check the main gas shut-off valve or the oven gas shut-off valve and call for service.
This code is not an error code. It indicates that the product's Sabbath mode
activated.
• See the "Using the Sabbath Mode" section in the Operation chapter.
The shiny, silver-colored racks were cleaned in a Self Clean cycle.
• Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
racks with the paper towel. Do not use lubricant sprays.
This means that the product has just been plugged in, or that it has experienced a
power interruption.
• This is normal. Reset the clock and any cooking function.
Possible Cause & Solution
k is no longer displayed.
is
sb