Ryobi OF35200VP Operator's Manual page 15

TROUBLESHOOTING
PROBLEM
Excessive moisture in
discharge air
Compressor runs continuously Defective pressure switch
Air output lower than normal
NOTE: ILLUSTRATIONS START ON PAGE 16 AFTER
POSSIBLE CAUSE
Excessive water in air tank
High humidity
Excessive air usage
Piston seal is worn
Broken inlet valves or worn seal and cylinder
Connections leaking
Drain valve not fully closed
FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a Three-year Limited Warranty.
For Warranty details go to www.RIDGID.com
Drain tank.
Move to area of less humidity; use air line
filter.
Take compressor to service center.
Decrease air usage; compressor not large
enough for tool's requirement.
Replace piston seal; call customer service
for assistance.
Take compressor to service center.
Tighten connections.
Close drain valve.
15 – English
SOLUTION