Table of Contents
Advertisement
7.2.3 Output Setup
Output Level Meter
This monitors the audio output level sent
to the speakers.
Output Name
This section list all available output channels. Each
output name can be customised to describe the type
of output connected. Changes made to the Output
Name will be reflected through the settings page.
Speaker
Select the product model for each channel that is
being used with the CDA-2HD. When using a non-
Bowers & Wilkins product, please choose any
User Preset.
Stereo / Mono
Allows each channel to be set for Stereo or Mono
operation. When Mono is selected the Left and
Right of the input selected will be combined to
create Mono.
Amplifier Mode
When more power is required, two channels can
be bridged into one channel. See 4.2 Connecting
to speakers on how to connect a Bridge-Tied
Load product.
7.2.4 Zone
CDA-2HD is a single zone product. This groups the
settings: Output Volume, Turn on Volume and Mute
on this product.
7.2.5 Output Volume
Output Volume
Main volume level control for each channel. When
channels are placed in the same Output Zone the
levels will change simultaneously.
Turn On Volume
In case of power outage, the TURN ON VOLUME
ensures the system always comes back on at the
same level. When channels are placed in the same
Output Zone the levels will change simultaneously.
Maximum Volume
Where high volume level is not required. Turn On
Volume and Output Volume will be capped at Max
Volume.This is an independent setting not affected
by the Output Zone.
Mute
Eliminates the output from the speakers.
Channels placed in the same Output Zone
will change simultaneously.
15
Advertisement
Table of Contents
