Hard Reset To Factory Default - Vivotek M500AG User Manual

- 500AG serials are operating in router mode so it is necessary to set WAN interface with
appropriate gateway. In this example, because the data packet is only going from one PC to
another, 500AGs set each other as default gateway.
It is recommended to confirm all the configurations are correct and properly saved by using
SMT-44 System Information. If directional antennas are used for this point to point application,
please check if the antennas are aligned properly by using SMT-41 Interface Link Status or the
command alt in SMT-45 Command Line.

4.5. Hard Reset to Factory Default

In the case of forgotten system password or any other situations that require setting 500AG back to
factory default without entering SMT, there is a reset button on the PCB inside the waterproof
housing for hard reset.
The reset button can be pressed any time after 500AG has enabled all the interface and shows
"Enable interface ath0" on the boot log when accessing 500AG with console.
Hardware Reset Button Push
Need More Than 10 Seconds.