Bridge Mode - Vivotek M500AG User Manual

4.3. Bridge Mode

Bridge mode is used when connecting two points in the same net scope. Here, the LAN of
192.168.1.0/24 is used as example to demonstrate how to configure two APs for point to point
connection in bridge mode. The figure is the topology for this point to point connection with
appropriate IP addresses for APs and PCs.
Taiwan Taichung Port South area
NB1 192.168.1.33
Device: M500AG
System Mode: Bridge
IP: 192.168.1.2
Interface: RF1
Operation Mode: AC (Wireless Station)
ESSID: pczonetest
Band: 802.11g (only)
Channel: 9
RF Output Power: 50mW = 17dBm
Limit Rate: 54Mbps
Multicast Rate: 11Mbps
Max RF Distance: 350
Command Line: rateadaption 0 13
rateadaption 1 3
Base on Point to Point 33km Bridge Mode Setting
Taiwan Yuan-li (Miaoli)
NB2 192.168.1.20
Device: M500AG
System Mode: Bridge
IP: 192.168.1.1
Interface: RF1
Operation Mode: AP
ESSID: pczonetest
Band: 802.11g (only)
Channel: 9
RF Output Power: 50mW = 17dBm
Limit Rate: 54Mbps
Multicast Rate: 11Mbps
Max RF Distance: 350
Command Line: rateadaption 0 13
rateadaption 1 3