Table of Contents
Advertisement
10
DOOR REMOVAL/REVERSAL
5. Pull the gray cable and connectors
through the hinge hole located on
the bottom of the cabinet using a
flat-head screwdriver.
6. Route the gray cable and the connec-
tors out from under the wheel axle
and the wheel spacer (see Figure 2).
Figure 2
7.
Slide the gray cable and connectors
out of the plastic channel located on
the bottom right side of the cabinet
(see Figure 3).
+
Figure 3
8. Remove the bottom hinge using
5/16" (8mm) wrench (see Figure 4).
Figure 4
9. Using a Phillips™ screwdriver,
remove the screws from the hinge
bearing and the door closer (see
Figure 5A).
10. Using a flathead screwdriver, gently pry
the door closer/hinge bearing assembly
out of the door (see Figure 5B).
11. Separate the door closer and hinge
bearing (see Figure 5C).
12. Flip the door closer over 180° and
reinstall the door closer onto the
hinge bearing (see Figure 5D).
13. Using a Phillips™ screwdriver, attach
the door closer/hinge bearing as-
sembly to the opposite side of the
door (see Figure 5E).
E
D
Bottom
Figure 5
C
A
B
Advertisement
Table of Contents
