JL Audio VX400/4i Manual page 13

the rear speakers. With only two EQ Banks, you can tune the entire eight-
channel system.
In the Basic PROJECT Level, the EQ Banks are fixed in a full-octave, graphic
EQ format that should be familiar to all audio enthusiasts. This provides a
fast, simple method for improving system frequency response.
In the Advanced and Expert PROJECT Levels, the EQ Banks can be used
in the aforementioned 10-band graphic EQ mode, or in fully Parametric
mode. 10 bands of Parametric EQ are even more powerful than a thirty band
graphic EQ. With full control over each EQ band's center frequency, "Q" and
boost/cut, you can correct response with incredible finesse and accuracy, and
thanks to the processing power of the TwK™, you can hear the immediate
effect of your adjustments, without any lag or muting.
"ROUTER" Panel:
The router establishes the connections and signal flow between the outputs
of the EQ Banks and the Output Channels. Like the Input Mixer, the Router
uses an intuitive, clickable interface that provides visual feedback of output
signal routing.
"DRC SETUP" Panel:
This panel allows you to configure the behavior of the DRC-200 that
is included with the TwK™. Check boxes allow you to determine which
channels will be controlled by the inner and outer knobs of the DRC-200.
By clicking on the "Menu"
control, fader and zone control functions for the outer knob of the DRC-200.
Appropriate setup check boxes will appear for each mode.
"OUTPUTS" Panel:
Output Channel labels can be edited and renamed by clicking and
highlighting the label. Use your PC's keyboard to create a new name.
Digital Output Source:
By selecting the "Menu"
input selector for the TwK's digital outputs. Using the pull-down menus,
select the TwK™ inputs that will feed the Optical Digital Output. Please
note that these signals pass directly from the inputs to the outputs with
no signal processing applied.
Page 10
, you may choose between subwoofer level
in the OUTPUTS panel, you can access the
|