Chapter 7: Remote Access Via Web Client - CONCORD QV5522 Manual

Chapter 7: Remote Access via Web Client

Use the Web Client to remotely access your Wireless NVR at any time via a PC. Before you access the Web Client,
you need to ensure that the network settings of the Wireless NVR are configured properly. The most convenient
and easiest way is if you have set the Wireless NVR a static IP address (please see "5.5.1 Network"). It means you
only need to open the web browser on your PC and type in the static IP address you have set on the Wireless NVR.
However, if the IP address of the Wireless NVR is assigned by a DHCP server (see"5.5.1 Network"), then it means
that each time you reboot the Wireless NVR, the IP address changes. In this case, ask if your ISP can provide you a
static IP address. If not, then configure the DDNS service. See the network settings in "5.5.4 DDNS".
System Environment Requirements
The minimum requirements for hardware and OS required to run Web Client are given as below.
Item
CPU
RAM
Hard Drive
Display RAM
Display Resolution
OS
DirectX
Direct 3D
Ethernet Adapter
IE
Mozilla Firefox
Google Chrome
Mac Safari
Minimum
Intel i3
4G or more
500G or more
2G or more
1280*1024
Windows® Vista, Windows® 7 ,Windows® 8
Mac OS X® 10.9 and above
DirectX 11
Acceleration Function
10/100M Ethernet Adapter
Microsoft Internet Explorer (Ver. 11, 10, 9, 8)
43.0.4 or above
V44 or below
5.1 or above
Recommended
Intel i7 or higher
8G or more
1000G or more
4G or more
1920*1080
66
66