Beko B7RCNE595ZXPW User Manual page 16

Using the product
3. Energy Saving (Display Off) Indicator
Energy saving function is enabled automatically and
the energy saving symbol (
the door of the product is not opened or closed
for some period of time. When the energy saving
function is active, all symbols on the screen other
than the energy saving symbol shall be turned off.
When the energy-saving function is active, pressing
any key or opening the door will deactivate the
energy-saving function and the display signals
will return to normal. The energy-saving function
is a function activated ex-factory and cannot be
cancelled.
4. Fault Condition Indicator
This indicator ( ) shall be active when your
refrigerator cannot perform adequate cooling
or in case of any sensor error. On the freezer
compartment temperature indicator the letter
"E" and on the cooler compartment temperature
indicator the numbers 1, 2, 3 will be displayed.
The numbers on the indicator specifies the service
regarding the failure. If you place hot food in the
freezer compartment or leave its door open for a
prolonged time, an exclamation mark can be lit. This
is not a fault, this warning shall be removed when
the food is cooled down or when any key is pressed.
5. Quick Freezing Key
When the quick freeze key is pressed, the LED
on the key is illuminated and the quick freeze
function shall be activated. Freezing compartment
temperature is set to -27 Celcius. Press the key
again to cancel function. The quick freezing function
shall be automatically cancelled after 24 hours. To
freeze a large amount of fresh food, press the quick
freeze key before placing the food in the freezer
compartment.
*Handle Light Function Setting Key
Handle light function might be switched between open
and closed modes by pressing quick freezing button
( ) for 3 seconds. In the closed mode, the handle
light is only activated when the appliance door is opened
and it goes out after a while after the door is closed. In
the open mode, the handle light is activated when the
Refrigerator / User Guide
) is displayed when
15 / 28 EN
appliance door is opened, the handle light stays on dimly
after a while after the door is closed. The handle light
function is set to the ex-factory closed mode.
6. Wireless Key
This button ( ) is utilized to connect wirelessly
to your appliance through HomeWhiz mobile
application. If the button is pressed for a long
time (3 secs) the LED on the button will blink
(in 0.5 second intervals). The link between the
appliance and the home network is initialized.
After the wireless connection with the appliance
is established the LED will be lit solid. After initial
setup, the connection can be activated/deactivated
by pressing this button. The LED on the button
shall flash quickly (at 0.2 second intervals) until the
connection is established. When the connection is
active, the LED shall light up continuously.
If the connection cannot be established for a long
period, check your connection settings and refer
to the "Troubleshooting" section provided in the
user manual. HomeWhiz application shall be used
for wireless connection. The steps for setup are
explained through the application during setup.
You can access the application by scanning the
QR code on the HomeWhiz label on the appliance.
The application can be obtained from App Store or
from Play Store for Android devices. For details visit
https://www.homewhiz.com/.
7. Cooling Compartment OFF (Vacation)
Function Key
To activate vacation function (
button for 3 seconds. The vacation mode will be
activated and the LED on the button will be lit. "- -"
shall be displayed on the Cooling Compartment
temperature indicator and the cooling compartment
does not actively perform cooling. You shall not
keep your food in the cooling compartment when
this function is activated. The other compartments
continue to cool according to the set temperatures.
Press the key for 3 seconds again to cancel this
function.
), press the