Icon Description - Hitachi PC-ARFG2-A Operation Manual

3. Operation Method

3.7 Icon Description

The status of the remote controller is displayed on the operation screen.
NOTES:
•
It may not be displayed depending on the type of outdoor unit or indoor unit you are using.
•
If there are multiple status, the high priority icon is displayed first.
No.
1
2
3
4
5
6
7
8 A/C
Vent.
THEX Vent.
9
Auto Vent.
Norm. Vent.
10
11
12
o
C
13 **
14 SAG
15 Temporary
16 Setback
17 Purging
18 Setback aborted
19 24-hour ventilation
20 Humidifier is run
21 Motion Sensor ON
22 Radiant Sensor
23 Cold draft restrained
24 Noise reduction
25 FrostWash is complete
IU temp. over range
26
FrostWash stopped
OU temp. over range
27
FrostWash stopped
Sav
Sav: Low
28
Sav: Med
Sav: High
29 Ext.Sav
10
Icon
A schedule timer is set.
Set the current time. Schedule timer operation is not possible.
The off timer is set.
The operation lock is set.
Displayed when using the central controller. Remote control operation is
restricted.
It is time to frostWash the heat exchanger.
It is time to clean the air filter.
Air-conditioning operation is performed.
Ventilation, automatic ventilation, total heat ventilation, and normal ventilation
are operating.
In Rotation operation.
In backup operation when abnormality occurs.
The standby refrigerant systems operate when abnormality occurs.
In backup operation in high load
If there is a difference between the room temperature and the setting
temperature, the standby refrigerant systems start to operate.
Displays the room temperature. (*1)
Elevating grille is not stored correctly.
Emergency operation is in progress.
When setback operation is enabled and the card key is removed (when no one is
present). (*2)
In night purge progress.
Setback is aborted.
24-hour ventilation is in progress.
The humidifier is in operation.
Indicates capacity savings by motion sensor control during operation or stop.
In order to efficiently heat the room when the radiant temperature is low, the
wind direction and air volume are automatically controlled.
In order to prevent indoor temperature from being too low.
The operation noise reduction control of the outdoor unit is set.
Indicates the frostWash is performed.
If the indoor temperature is out of the range of 59°F(15°C) to 86°F(30°C), no
frostWash is performed and the cancellation is displayed.
If the outdoor temperature is out of the range of 34°F(1°C) to 110°F(43°C), no
frostWash is performed and the cancellation is displayed.
Either the outdoor capacity control, indoor rotation control, or intermittent
operation control is set.
Outdoor capacity control is set on the central controller or outdoor unit.
It does not light when the indoor rotation control or intermittent operation
control of the remote controller is set.
Description
A16381TMEU