Table of Contents
Advertisement
•
Unit stops running:
Mains supply is disconnected or has failed
Target temperature has been reached.
Timer has been set.
Water tank is full (E6 will be displayed)
•
In cooling mode, no cool air is produced:
Room temperature is lower than set temperature
The unit is defrosting (this will take a few minutes, and afterwards,
it will resume operation)
Filter is blocked
•
Cooling is poor on hot days
Too much direct sunshine is heating the room
Windows or doors are open allowing hot air into the room
A lot of people in the room (each person contributes about 75W of
heating)
Electrical equipment in the room producing heat
•
Remote control does not work:
Check batteries are correctly installed, and are not exhausted.
Make sure that the remote control is pointed towards the main unit
when being used.
•
Water leakage
Drain hole slopes the wrong way
Drain tube not fitted correctly
•
Water splashes out of the front of the appliance
Appliance has not been installed level.
If any error codes appear on the display, contact your local service
agent.
E2: Indoor room temperature sensor failure
E4: Indoor coil sensor failure
E5: Failure of upper fan motor
E6: Water tank full
FAULT CODES
TECHNICAL SPECIFICATION
Page 11
Advertisement
Table of Contents
