Table of Contents
Summary of Contents for Prem-I-Air EH1329
- Page 1 EH1329 Indoor Climate Control 2.3 kW of cooling, 2.4 kW of heating Air Conditioning Efficient heating (air-source heat-pump) Cooling Remote control Suitable for high- or low-wall installation No external unit required 3 Fan speeds Page 1...
-
Page 2: Before Use
IMPORTANT Installer and Users please note: These instructions should be read carefully and left with the user of the product for future reference. BEFORE USE Inspect the product including its cable and plug for any signs of damage. If the product is damaged, DO NOT use it, and contact your supplier immediately. -
Page 3: Installation
INSTALLATION The appliance weighs 32kg. In order to comply with Health and Safety Manual Handling guidelines, two people will be required to lift it. Transport and store in an upright position. Leave the unit in an upright position for at least 3 hours before first use. Choose the optimum location for the appliance: It must be on an external wall with 2m... - Page 4 wall using the screws provided, then fit the drainage tube into the 30mm hole and seal with foam as above. If the outside of the wall is not accessible, proceed as follows. Attach the nylon cords to the rubber ring as shown. Fold the rubber ring in half and pass it through the hole, keeping hold of the other ends of the nylon cords.
- Page 5 If the mains lead is fitted with a Schuko plug (with two round pins), either fit the 13A plug adaptor provided, or remove the Schuko plug and fit a 13A plug. Alternatively, remove the plug and wire to the mains supply via a switched fused spur.
-
Page 6: Product Safety
PRODUCT SAFETY • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. -
Page 7: Operation
OPERATION Plug the mains lead into a 13 Amp mains socket (unless permanently installed) If connecting via an extension lead, make sure that the lead is rated at 13 Amps or more, and that it is fully unwound. Switch the appliance on at the mains socket. Press the ON/OFF button to start the appliance. -
Page 8: Using The Timer
UP and DOWN buttons: Use the UP and DOWN buttons to select the desired room temperature. The temperature can be set to any temperature from 16 °C to 31 °C. Selecting a lower temperature whilst heating, or a higher temperature whilst cooling will reduce power consumption. When either TEMP button is pressed, the display will show the set temperature for 5 seconds, then will revert to showing the room temperature. -
Page 9: Maintenance
Sleep Mode When cooling, sleep mode increases the temperature by 1°C per hour for the first two hours, then maintains the temperature 2°C above the set temperature for the next six hours. The fan runs at the lowest speed. When heating, sleep mode decreases the temperature by 1°C per hour for the first two hours, then maintains the temperature 2°C below the set temperature for the next six hours. -
Page 10: Disposal And Recycling
Every two weeks, clean the air filter − the filter is located at the back of the appliance towards the top. Remove the filter, and wash with hand-hot water with a drop of detergent. Dry thoroughly before replacing. Using the appliance with a blocked filter will severely reduce its efficiency, and using without the filter may lead to a build-up of a dust on the heat exchangers, which may constitute a fire hazard. -
Page 11: Fault Codes
• Unit stops running: Mains supply is disconnected or has failed Target temperature has been reached. Timer has been set. Water tank is full (E6 will be displayed) • In cooling mode, no cool air is produced: Room temperature is lower than set temperature The unit is defrosting (this will take a few minutes, and afterwards, it will resume operation) Filter is blocked... -
Page 12: Service / Warranty
Refrigerant R410a (450 g) SERVICE WARRANTY Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of twelve months. Should this appliance be operated under conditions other than those recommended, at voltages other than the voltage indicated on the appliance, or any attempts made to service or modify the appliance, then the warranty will be rendered void.