Table of Contents
Advertisement
1. Follow "DRAWER ASSEMBLY AND CHOKE REMOVAL" (steps 1-5)
2. Lay the door panel & door frame assembly front down on a protective surface.
3. Remove the (11) screws holding door panel to door frame (Fig. L-1).
4. With the door frame removed, unhook latch/s spring, then remove screw.
5. Proceed in reverse to reinstall.
6. Adjust switches after assembled back to the cavity.
Door Panel screw
to door frame
Latch head L
Latch head screw
Note: The drawer on a microwave oven is designed to act as an mechanical seal preventing the leakage of
microwave energy from oven cavity during cook cycle. This function does not require that door be air-
tight, moisture (condensation)-tight or light-tight. Therefore, occasional appearance of moisture, light
or sensing of gentle warm air movement around oven drawer is not abnormal and do not of themselves
indicate a leakage of microwave energy from oven cavity.
DOOR LATCH REMOVAL
Fig. L-1
Door Panel
Door Panel screw
Latch spring
to door frame
Door frame
Door Panel screws
to door frame
Latch head R
Latch head screw
Latch spring
Door Panel screw
to door frame
30
Advertisement
Table of Contents
