Oven Installation; Installation And Connection - Defy DBO767-Black Instruction Manual

Oven installation

Insert the oven into the cupboard.
•
Open the door to expose the fixing holes in the side trims.
•
Secure the oven by 4 countersunk screws (fasteners are not supplied).
•
Note:
Allow for a 10
mm gap
between the
aperture edge
and the adjacent
cupboard to
allow for
unobstructed
opening of the
oven door
.
100 MIN
32
Support the oven in front of the aperture
•
and make the electrical connection before
installing. This will ensure enough cable
length for subsequent servicing.
Slide the oven fully into the cabinet before
•
securing it.

Installation and connection

The appliance must be installed in
accordance with all local gas and electrical
regulations.
Electrical installation
This appliance must be earthed and the
manufacturer and the seller do not accept
responsibility for any damage due to
incorrect installation or electrical connection.
This appliance should not be connected
through an earth leakage system.
Refer to S.A.N.S.10142.
Page 10
Aperture Aperture
APERTURE
1085 H x 700 W x 580 D
1085 H x 700 W x 580 D
1085 H x 700 W x 590 D
+ _ 3
700
0
Aperture
32
100 MIN
+ _ 3
1085
0
Aperture
+ _ 3
600
0
Above floor
level
Floor
Fixing holes are located on the side trims.
•
Secure the oven by inserting small wood
screws through these holes into the cabinet
side wall. (screws are not provided).
It is adequate to only secure the unit on one
•
side. (same side as the handle).
Connection to the power supply
The connection must be carried out by a
licensed electrician, who will ensure that the
oven is correctly connected and safely
earthed. The rated current is printed on the
serial number label attached to the oven side
trim.
The appliance must be connected to the
mains through a double pole isolating switch
which has a minimum clearance between the
contacts of 3 mm. in both poles.
A means for disconnection must be provided
in the fixed wiring.
+ _ 3
60
0
Typical section showing
ventilation requirements