Victron Pylontech UP2500 Manual
  1. Manuals
  2. Brands
  3. Victron Manuals
  4. Battery Pack
  5. Pylontech UP2500
  6. Manual

Victron Pylontech UP2500 Manual

Hide thumbs Also See for Pylontech UP2500:
Table of Contents

Advertisement

Quick Links

Victron & Pylontech UP2500, US2000, US3000, US2000C, US3000C, US5000, US5000B, UP5000, Phantom-S, Force-
2023-02-21 22:12 1/12
Victron & Pylontech US2000, US3000 and
Phantom-S
The combination of Victron products with Pylontech lithium batteries has been tested and certified by
the Victron and Pylontech R&D departments.
General information about the battery is found in Pylontech's documentation.
This manual is intended to be used in conjunction with the product manual supplied by Pylontech. It
provides additional and specific information regarding integration with Victron systems.
The Pylontech includes a Battery Management System (BMS) with each battery module. This
interfaces with the Victron
1. Product & system compatibility
Battery UP2500 US2000 (Plus) US3000 Force-L1
Nominal voltage
24V
Module capacity 2.55 kWh
1.1 Offgrid, Backup and Energy Storage Systems are possible
Victron + Pylontech can be used for the following system types:
Off-grid
(DVCC)
Grid Backup
(DVCC
Energy Storage Systems (ESS) - Self Consumption
1.2 A GX-device is required, eg Cerbo GX or Venus GX (VGX)
It is essential to use the CAN-bus connection of the
batteries for the keep-alive signal, communication of charge and discharge limits, error codes and
state of charge.
Victron Energy - https://www.victronenergy.com/live/
GX device
and can support multiple battery modules connected in parallel.
48V
48V
2.4 kWh
3.5 kWh 3.55 kWh
or
ESS)
48V
(ESS - Start
page)
GX device
(e.g. Cerbo GX or CCGX) with the
L1 & L2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Pylontech UP2500 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Victron Pylontech UP2500

Summary of Contents for Victron Pylontech UP2500

  • Page 1 L1 & L2 Victron & Pylontech US2000, US3000 and Phantom-S The combination of Victron products with Pylontech lithium batteries has been tested and certified by the Victron and Pylontech R&D departments. General information about the battery is found in Pylontech's documentation.

  • Page 2: Minimum Battery Sizing Recommendations

    1.4 All VE.Direct BlueSolar and SmartSolar MPPT Chargers are compatible For proper operation, the Pylontech battery needs to be able to control the charge current. Therefor it is recommended to use Victron 48V compatible MPPTs models with VE.Direct port for charging. MPPTs with a VE.Direct port MPPTs are controlled via the device.

  • Page 3: Can-Bus Wiring

    Victron & Pylontech UP2500, US2000, US3000, US2000C, US3000C, US5000, US5000B, UP5000, Phantom-S, Force- 2023-02-21 22:12 3/12 L1 & L2 The charge and discharge rates are managed automatically by the Pylontech battery and device. Using very large solar arrays with battery banks that are too small can exceed the limits of the batteries ability to charge and possibly lead to the BMS triggering over-current alarms.
  • Page 4 BMS type B Cable, part number ASS030720018, you cannot use the cable supplied by Pylontech. Plug the type B cable with the side which is labeled Battery BMS into the Pylontech CAN port of the master battery. Plug the side labeled Victron VE.Can into the device.

  • Page 5: Veconfigure Settings

    Victron & Pylontech UP2500, US2000, US3000, US2000C, US3000C, US5000, US5000B, UP5000, Phantom-S, Force- 2023-02-21 22:12 5/12 L1 & L2 4. VEConfigure Settings When using the latest firmware on all compatible connected devices, and once the battery module has been detected by the GX device, battery charging parameters (e.g. Maximum Charge Current, Target Battery Voltage, etc) are automatically configured by the Pylontech BMU, and communicated...
  • Page 6 Last update: battery_compatibility:pylontech_phantom https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom?rev=1590396991 2020-05-25 10:56 * The pre-alarm setting is dependant on your preference and on site specific requirements. You may wish for this to be activated earlier in an off grid situation to allow time to start a backup generator. ESS System Settings If you are using the battery as part of a grid connected ESS...
  • Page 7 Victron & Pylontech UP2500, US2000, US3000, US2000C, US3000C, US5000, US5000B, UP5000, Phantom-S, Force- 2023-02-21 22:12 7/12 L1 & L2 Over-charge and Over-discharge Current Limit 102A for 15 seconds, 200A for 0.1 seconds and 400A short circuit current. If operation is attempted outside the operating range, the battery will disconnect to protect itself.

  • Page 8: Ve-Direct Mppt Settings

    Last update: battery_compatibility:pylontech_phantom https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom?rev=1590396991 2020-05-25 10:56 This parameters page is also a good place to check that all batteries are connected and working properly. In normal working conditions, the current limit is 25A per cell. For example, 75A charge current limit ( 75 / 25 = 3 ) means there are 3 Pylontech battery modules connected. 6.

  • Page 9: Troubleshooting

    Victron & Pylontech UP2500, US2000, US3000, US2000C, US3000C, US5000, US5000B, UP5000, Phantom-S, Force- 2023-02-21 22:12 9/12 L1 & L2 8. Troubleshooting If the system is not operating correctly, go through these steps. Step 0. If the Inverter/Charger or GX device does not switch on...
  • Page 10 If its not visible, check: GX device firmware version (update to latest version, v2.15 or later) CAN-bus communication cabling between Pylontech and Victron system. Make sure that it is in the right way around. Pylontech system is up and running (LEDs are on) Step 2.

  • Page 11: Further Information

    Victron & Pylontech UP2500, US2000, US3000, US2000C, US3000C, US5000, US5000B, UP5000, Phantom-S, Force- 2023-02-21 22:12 11/12 L1 & L2 grid, the inverter can draw more than the 25A limit to run the loads, make sure you have sufficient batteries installed to keep the load per battery around this limit.
  • Page 12 Last update: battery_compatibility:pylontech_phantom https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom?rev=1590396991 2020-05-25 10:56 Further community discussion about installing and using Pylontech and Victron can found at Victron Community, use the topic label 'Pylontech'. DISQUS View the discussion thread. From: https://www.victronenergy.com/live/ - Victron Energy Permanent link: https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom?rev=1590396991 Last update: 2020-05-25 10:56 https://www.victronenergy.com/live/...

This manual is also suitable for:

Pylontech us2000Pylontech us3000Pylontech us2000cPylontech us3000cPylontech us5000Pylontech us5000b ... Show all

Table of Contents