Table of Contents
Advertisement
Figures 11 and 12 illustrate the wiring
connections for optional wall control (The
wire color out of wall control may vary, see
wall control's installation manual for
correct wire connections.)
WARNING: TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR OTHER PERSONAL
INJURY. MOUNT FAN ONLY ON AN OUTLET
BOX OR SUPPORTING SYSTEM MARKED
ACCEPTABLE FOR FAN SUPPORT.
7. FINISHING THE
INSTALLATION
Step 1. Tuck connections neatly into
ceiling outlet box.
Step 2. Slide the canopy up to ceiling
and over the two screws on hanger
bracket. Rotate canopy clockwise, next,
while holding the canopy with one hand,
slide the canopy cover over the screws
and rotate clockwise until tight. Note:
adjust the canopy screws as necessary
until the canopy and canopy cover are
snug. (Fig.13)
Warning: Make sure tab at bottom of
hanger bracket is properly seated in
groove of hanger ball before attaching
canopy to bracket. Failure to properly seat
tab in groove could cause damage to
electrical wiring.
8. ATTACHING THE FAN
BLADES
Caution: Remove 5 rubber packing
mounts and discard before installation.
Step 1 Attach the blade to the blade
bracket using the screws and rubber
washers as shown in Figure 14. Start screw
into bracket. Repeat for the two remaining
screws.
Step 2 Tighten each screw. Make sure the
blade are straight.
Step 3 Fasten blade assembly to motor
using the screws supplied. (Fig. 14)
FAN
LIGHT
Outlet box
Hanger
bracket
Screws
6
POWER LINES 120V
GREEN
GROUND
WIRING
BOX
GROUND TO
MOUNTING
BRACKET
OR DOWNROD
FAN
BLUE
WH
BLK
WH
LIGHT
Figure 12
Canopy cover
Figure 13
Set of blades bracket
Figure 14
Screws
Canopy
Screws
Rubber
washers
Blade
Advertisement
Table of Contents
