Make The Electric Connections - Designers Fountain 52TB3L5-NI Owner's Manual

CHANGING THE DOWNROD (OPTIONAL)
NOTE: Your fan comes with a 6" downrod
attached to the hanger ball. In addition
you have been provided with a 4"
downrod to use if desired. If you choose to
use the 4" downrod, perform the following
steps:
1. Remove the hanger ball from the 6"
downrod by loosening the set screw at the
top of the downrod which holds the
hanger ball to the downrod. (fig. 9)
2. Slide the hanger ball down the downrod
and remove the support pin. (fig. 9)
3. Insert the support pin in the holes at the
top of the 4" downrod and slide the
hanger ball up the 4" downrod. Make sure
the support pin is properly seated in the
grooves in the top of the hanger ball.
4. Tighten the set screw firmly.
6. MAKE THE ELECTRIC
CONNECTIONS
Remember to disconnect the power.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan.
Secure the connectors with electrical tape.
Make sure there are no loose strands or
connections.
Step 1 Connect the fan supply (black) wire
and light supply (blue and orangr) wire to the
black household supply wire as shown in
Figure 10.
Step 2. Connect the neutral fan (white)
wire to the white neutral household wire.
Step 3 Connect the fan ground wire
(green) to the household ground wire.
Step 4 After connecting the wires, spread
them apart so that the green and white
wires are on one side of the outlet box and
the black and the blue wires are on the
other side.
Step 5 Turn the connecting nuts upward
and push the wiring into the outlet box.
Hanger
ball
POWER LINES 120V
BLUE
LIGHT
SWITCH
BLUE
5
Cross pin
Set screw
Downrod
Figure 9
GREEN GROUND
WIRING
BOX
GROUND TO
MOUNTING
BRACKET
OR DOWNROD
FAN
WH
BLK
WH
LIGHT
Figure 10
POWER LINES 120V
GREEN GROUND
WIRING
BOX
GROUND TO
MOUNTING
BRACKET
OR DOWNROD
FAN
WH
BLK
WH
LIGHT
Figure 11