AGFA CG Triumvirate TT042-50 Series User Manual page 36

3.1.1-1.1 Speed:
Print Setup
> Speed
Density
Direction
Use this option to setup print speed. Each increment/decrement is 1 ips. Printer default
density is 5 ips (203 dpi) or 3 ips(300 dpi).
Press
speed. Press
setting and return to the previous menu.
Note: If printing from enclosed software/driver, "Use current printer settings" option
is not selected, the software/driver will send out the SPEED command, which
will overwrite the setting set from the front panel.
3.1.1-1.2 Density:
Print Setup
Speed
> Density
Direction
Use this option to setup printing darkness. The available setting is from 0 to 15 levels, and
the increment is 1 level. Printer default density is 8.You may need to adjust your density
based on selected media/ribbon.
Press
key to enable the setting. Press
to the previous menu.
Note: If printing from enclosed software/driver, the "Use current printer settings"
option is not been used, software/driver will send out the DENSITY command,
which will overwrite the setting set from the front panel.
3.1.1-1.3 Direction:
Print Setup
Speed
Density
> Direction
The direction setting value is either 1 or 0. Use this option to setup the printout direction.
Printer default printout direction is DIRECTION 0.
1/12
key to raise the print speed, and press
key to set it into printer. Press
2/12
and to increase/decrease the printing darkness. Press
3/12
Speed
6
Density
8
key to cancel the setting and return
Direction
0
29
key to decrease print
key to cancel the