Omron SYSDRIVE 3G3EV User Manual page 41

Compact low-noise inverter

Hide thumbs Also See for SYSDRIVE 3G3EV:

Design

D Wiring Method

•The wiring procedure is the same as for sequence input/output terminals, described

previously.

•Always separate the cables from the main circuit cables and other power cables.

•Connect the shield to the ground terminal of the Inverter. Do not connect to the control-

ler.

•Insulate the shield with tape to prevent it from coming into contact with other signal

lines and devices.

H Tightening Torque of Control Circuit Terminals

Tighten the control circuit terminals to the torque of 0.5 N S m which is the same torque

as for the M3 screws.

Note 1. Applying a torque of greater than 0.5 N S m may damage the terminal block.

Note 2. If the tightening torque is insufficient, wires may be disconnected.

Chapter 3

3-21