Project Source 05535040 Assembly Instructions Manual page 7

ASSEMBLY INSTRUCTIONS
3. At this point stand up the front or back frame and add 7
male braces (G). Then stand up another frame and add 7
female braces (H). Connect the first and second frame
along with diagonals (F). For the remaining frames use
the male braces (G). Add the diagonals F between the
last two frames.
NOTE: PUT PLASTIC CAPS ON ALL OPEN ENDS OF
TUBES"G" AND 'H' ALSO ON TUBES "A".
Hardware Used
Q
M6 x 100 mm Bolt
4. Before you install the tarp, make sure the distance
between the legs (AC, BD) is 18 feet wide, including the
legs. Also verify that diagonal distances AD and BC are
equal, and lengths AB and CD are equal.
5. Take the tarp and place it over the structure. Make sure
that the windows are on the two sides of the shelter, at
the front or at the back as your choice. Make sure ties
are on the inside.
3
x 20
4
5
Page 7