Advertisement
STEP 24: (FINISHING TOUCHES)
24.1 It may be necessary to roll out the right side frame's
bulb rubber around the CAUTION decal found on the
top of the right fender. See Figure 24.1
24.2 Remove the protective film from rear leg, lower door,
and/or cowl windows if present at this time.
24.3 Due to the nature of the packaging materials used for
shipping this product, the components of the cab
system may have dust on their surfaces upon removal
from the packaging. It is recommended that after
completion of the cab installation, the cab and vehicle
are washed thoroughly to eliminate any dust or
contaminants. See the Care and Maintenance section
below for critical information on cleaning the cab.
24.4 For best seal, massage the rubber seal between the
side frames and the fenders with a putty knife, pushing
in or out, to close any gaps in the area shown in Figure
24.4.
•
Re-apply lubrication (preferably grease) periodically as needed to the door striker pins, door latch assemblies, and the door
hinges.
•
Check and tighten hardware after 40 hours of operation. Periodically inspect and tighten hardware for the remainder of the
unit's life.
•
Wash the painted surfaces of the cab with commercial automotive cleaning products.
•
Clean glass windows with glass cleaner. Note: Some windows on the cab are acrylic. DO NOT clean acrylic windows with
harsh chemicals. It will damage the plastic. Mild soap and water should be used on all acrylic windows.
CAB INSTALLATION
CARE AND MAINTENANCE
Fig. 24.1 (Right Fender - Caution Decal)
Fig. 24.4 (Fender Seal, right side shown)
17 of 25
Advertisement
