Sys Adjust Menu; Maintenance Menu - Oki C3000 Series Manual

S A
YS DJUST MENU
Not displayed as default. This menu is displayed only when set to ENABLE in OP MENU
of Administrator menu.
ITEM SETTINGS
X ADJUST +2.0mm
~
0
~
-2.0mm
Y ADJUST +2.0mm
~
0
~
-2.0mm
DRUM ON
CLEANING
OFF
HEX DUMP EXECUTE
M
AINTENANCE MENU
This menu provides access to various printer maintenance functions.
ITEM SETTINGS
MENU RESET EXECUTE
SAVE MENU EXECUTE
RESTORE EXECUTE
MENU
POWER SAVE ENABLE /
DISABLE
PAPER BLACK –2~0~+2
SET
EXPLANATION
Adjusts the position of a whole print image in the direction perpendicular to
the direction the paper runs, that is horizontally, in 0.25 mm increments.
Any parts of the print image that are outside the printable area as a result of
this shift will be cropped.
Adjusts the position of a whole print image in the direction the paper runs,
that is vertically, in 0.25 mm increments.
Any parts of the print image that are outside the printable area as a result of
this shift will be cropped.
Corrections in a negative value are ignored in PS mode.
Sets whether to rotate the drum in idle prior to printing in order to reduce
any horizontal white lines.
CAUTION: Each additional rotation will shorten the ID life by that
amount.
Prints out data received from the host PC in hexadecimal Dump. Turning off
the power supply switch restores Normal Mode from HEX Dump Mode.
EXPLANATION
Resets menus to default settings.
Saves the current menu settings. The last menu executed is saved and
the menu previously saved is overwritten and erased.
When you press the ENTER button, the following confirmation message is
displayed.
"DO YOU WANT TO EXECUTE THIS FUNCTION?" YES/NO
If you select NO, the display returns to the previous menu.
If you select YES, the current menu settings are stored and the menu is
exited.
Changes to the menu setting saved.
When the Enter button is pressed, the following confirmation message
appears.
ARE YOU SURE? YES/NO
If NO is selected, the previous menu display resumes. If YES is selected,
changes made to the menu setting are saved and you exit from the
menu.
Notes:
This cannot be executed when data is printing.
THis menu item will only show if the menu has been saved previously
Enables or disables automatic power save mode.Delay before entering
this mode is set in the SYSTEM CONFIGURATION menu.
Used for small adjustments when you experience faded print or light
specks / streaking in monochrome printing on white paper. Select a
higher value to reduce fading, or a lower value to reduce specks or
streaking in high density print areas.
Menu functions > 31