Trulife Seattle LightFoot SLF190 Installation And User Manual

INTRODUCTION

The Seattle LightFoot² with Titanium Pyramid is approved for use by all lower extremity amputees with low to medium activity
levels. Its Delrin keel provides rollover assistance and stability. The Seattle LightFoot² with Titanium Pyramid is available in two
heel rises (3/4" and 3/8") and three color options.
Product Code Description
SLF190 Caucasian
SLF191 Light Brown
SLF193 Dark Brown
SLF195 Caucasian
SLF196 Light Brown
SLF198 Dark Brown

LIMITATIONS

The Seattle LightFoot² with Titanium Pyramid cannot be used with R.O.L rotators or other devices that require modification of
the keel.

INSTALLATION AND USE

Recommended installation and use procedures must be followed for maximum safety and service life.
The Seattle LightFoot² with Titanium Pyramid comes pre-assembled with a Trulife spacer, foot pyramid and foot bolt. Before
installation, check the bolt for loosening, ensuring that the bolt is set to a torque value of 27 Nm (20 ft-lbs or 240 in-lbs).
Warning: Never modify the keel. It will void the warranty and can cause bolt or keel failure. If you must alter the form of
the foot, be sure not to grind on the keel.
Warning: Never re-drill the mounting hole.
Warning: Never modify the spacer. It will void the warranty and may cause failure.
Warning: Use only bolts supplied by Trulife. Use of unapproved bolts will void the warranty and can cause bolt failure.

Endoskeletal Installations

When using the Seattle LightFoot² with Titanium Pyramid with a Seattle Endoskeletal Cosmesis, remove the foot from the
endoskeletal limb. Completely rough the mounting surface of the foot and cosmesis. Remove all foam particles from the abraded
surfaces. If desired, apply small reference marks to the mounting surfaces to facilitate careful matching of the surfaces. Apply a
thin layer of contact cement to each surface and allow it to dry. Apply a second layer of contact cement and allow to dry. Match
the two surfaces carefully and press them together tightly both on the outside and inside of the seam.

Color Coating

Before applying color coating to the foot, remove any remaining mold release from the cosmesis with naphtha. Naphtha is
recommended to improve the adhesion of color coating, but alcohol can be used as well.

ALIGNMENT

The recommendations in this guide provide reliable starting points for static alignment of the Seattle LightFoot² with Titanium
Pyramid. Since each patient is unique, final alignment may require additional adjustment.
Trulife • 26296 Twelve Trees Lane NW, Poulsbo, WA 98370 •
Heel Rise
3/4"
3/4"
3/4"
3/8"
3/8"
3/8"
888.878.1238 • 888.878.1237 • www.trulife.com
tel fax
SLF190, 191,193, 195, 196,198
Seattle LightFoot² with Titanium Pyramid
Installation and User Guide
Patient Weight
136 kg / 300 lb (Med. Activity)
136 kg / 300 lb (Med. Activity)
136 kg / 300 lb (Med. Activity)
136 kg / 300 lb (Med. Activity)
136 kg / 300 lb (Med. Activity)
136 kg / 300 lb (Med. Activity)
28902-001 REV B
Page 1 of 2